Embedded Files
View from Garden to Garage.
Wiring exists inside the Garage on a separate circuit. We need new armoured cable out of Garage to Shed
Shed is 12x10 foot and I am looking to run 3 circuits from the shed, 1 for lights, bije and network switch in shed, then later to add circuit for lights around patio, and another circuit for lights in garden.
From the back of the shed towards garage, wires will enter shed at the rear corner shown.
Electrics to be mounted inside shed in corner, somewhere suitable.
The circuit in the garage, needs a hole put in the garage wall, and armoured cable up to the shed.
Inside shed
Circuit 1: 4 sockets 200W
Circuit 2: 1 socket, I will use this for a water pump 800W 3A, for watering garden.
Circuit 3: lights with switch by door 40W
A later job I will need to do is to fit 2 new circuits in the garden (Note if we can use the board in the shed to serve these circuits, then perfect, otherwise if we need more circuits out of the garage then we need to get this done as part of this job now).
Circuit for lights around patio (old wire/lights) replaced. (5 lights x 10Watts 240V)
Circuit for lights around the perimeter of the garden. (12 lights x 10Watts 240V)
Report abuse